高压清洗机的冲洗能力强，能去除地面等物体表面的污垢与油污渍等。小编特地整理一份高压清洗机的使用说明，方便大家随时随地查询。高压清洗机的使用说明如下：

High pressure washing machine has strong washing capacity, and can remove dirt and oil stains on the surface of objects such as the ground. I specially compiled a manual for the use of high-pressure cleaning machine, which is convenient for you to inquire at any time and anywhere. The operating instructions of the high-pressure washer are as follows:

1、接好高压清洗机的电源开关；

1. Connect the power switch of the high-pressure washer;

2、通电时，主要要把喷枪打开，避免出现回流水现象和机器发热；

2. When the power is on, the spray gun should be turned on to avoid backflow water and machine heating;

3、初次使用高压清洗机时，使用够20个小时后更换机油（机油用摩托车机油就可）；

3. When using the high-pressure washer for the first time, change the engine oil after 20 hours of use (motorcycle engine oil is enough);

4、第二次以后，使用100个小时后更换一次机油；

4. After the second time, replace the engine oil after 100 hours of use;

5、冲洗时，压力慢慢加大，不要一次加到大，以避免机器发热；

5. During flushing, the pressure shall be increased slowly, not at one time, to avoid heating of the machine;

6、冬天使用时，注意要涂防冻液；

6. When using in winter, pay attention to applying antifreeze;

7、加机油时，注意加油量，加到油缸规定红线稍高就可；

7. When adding oil, pay attention to the amount of oil, and add it to the specified red line of the oil cylinder slightly higher;

8、冲洗时，切忌将水枪对着人，以避免伤人；

8. When washing, never point the water gun at people to avoid injury;

9、间歇式冲洗时，停枪的时间不要超过2分钟，以避免回流、机器发热；

9. During intermittent flushing, stop the gun for no more than 2 minutes to avoid backflow and machine heating;

10、停机时，注意先关电源。

10. When shutting down, turn off the power first.

CNC高压清洗机日常操作与使用说明的相关内容麻豆操逼视频就讲解到这里了，您对此有什么想咨询的问题就来麻豆操逼视频网站www.lewjj.com咨询看看吧！

This is the end of the daily operation and use instructions of the CNC high-pressure washer. If you have any questions, please come to our website www.lewjj.com for consultation!